Billet locker knob specifically made for 2005+ Ford SuperDuty trucks with locking front hubs and using Innov8 Racing open front center caps.
NOTE: These caps only work on aftermarket wheels with a ...
Fuel Economy was tested on the Mustang dyno using the OBD-II fuel flow rate and vehicle speed data, as well as the Banks emissions analyzer to measure fuel economy calculated from tailpipe emission...
On vehicles equipped with a two piece drive shaft & carrier bearing, there is the potential for take off vibration, depending on the severity, this can be corrected with shimming down the carri...
SKU: CS-CARRIERDROP-F– Drops Carrier Bearing on 2-Piece Driveshafts– Prevents take-off shudder/driveline vibration– Stackable 3/8″ Shims for 1″-4″ Rear Lift
The carrier bearing drop is needed for a...
Made from a thick A356.0-T6 aluminum and is much stronger than the factory stamped steel cover.
The MIL-Spec black anodized finish adds a sleek aesthetic but provides protection against the element...
Don’t need a 7075 knuckle for your 2005+ Superduty axle, but want something with double-sheer and hi-steer? These knuckles bridge the gap between a stock knuckle and our 7075 offering to bring you...
