Free Shipping on Orders Over $200*
EGT's running too high? Can't use all of the fuel you have available? The Air-Boss VP plenum gives the largest bolt-on flow increase possible short of milling the cast plenum off the head and installing a fabricated intake plenum.
The Air-Boss VP isn't just a replacement flat aluminum plate as seen in other designs. The Air-Boss VP is an internally elevated plate designed to flow as much air as possible to cylinders 4, 5, and 6. Turning ramps at the plenum entrance aid incoming air thru the transition area. With our plate design we open up the plenum area to the starving rear cylinder by a full 20%. By increasing airflow to the rear cylinders we reduce EGT's and allow you to run even higher fueling levels.
The Air-Boss VP plenum kit also includes a shortened grid heater delete block to maintain the factory IC piping to intake manifold connection geometry . Maintaining this geometry makes the Air-Boss VP compatible with ALL aftermarket intake manifolds and the stock mounting hardware.
Grid Heater options:
A) The standard Air-Boss VP kit includes a custom height grid heater delete block.
B) For colder climates we now offer the Air-Boss VP with a grid heater option. This option uses the factory grid heater (no delete included) and custom length stainless steel studs to accomodate the increased plenum height of the Air-Boss VP.
C) For customers that want to swap back and forth between the heater and delete block we offer both item in one package.
Kit includes: Air-Boss VP intake plenum plate, factory gaskets, custom height grid delete block and/or optional stainless steel studs.
Write the First Review!
You must login to post a review.